Alcoa SFBTT20-IT SFBTT20-IT Instruction Manual download pdf (Page 9)

Utilisation

Swage Swage

Pressure Pressure

Bobtail Tool Pull Installation Collar Cutter

Model Fastener Pressure Nose Assy. Assy. Return Pressure

Series Diameter Max. bar/psi Max. bar/psi Max. bar/psi Max. bar/psi

BTT25 12 mm 389/5640 289/4200 235/3408 289/4200

BTT25 14 mm 389/5640 340/4930 290/4205 289/4200

BTT35 16 mm 380/5510 357/5177 270/3915 350/5075

SFBTT20 16 mm TBA TBA TBA

BTT57 20 mm TBA TBA TBA

!""#$%&'()*+$,()*(-$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$./0&1$21-3(4*4+$,5-3(6-

Huck Tool Pull Pressure Return Pressure

Series/Model Max. bar/psi Max. bar/psi

2400, 2480 (See Note below) 579/8400 221/3200

2502, 2503 (See Note below) 579/8400 165/2400

2580 Series 393/5700 221/3200

2600 Series 393/5700 193/2800

2620,2624, 2628, 2630 Series 510/7400 221/3200

506, 507, 585, 586, 5901, 393/5700 165/2400

516, 520, 524, 528, 532, 536

6042, 7042, 8042 510/7400 221/3200

Non-Bobtail T ools

Note

Pressures may be reduced for some smaller diameter Fasteners. Refer to appropriate

Installation Tool Instruction Manual.

Bobtail T ools

Notes

1)The above Swage Pressures are only a guide and may have to be adjusted to obtain

consistent correct Collar swaging. The Pull Pressure should always be a maximum of

60 (870 p si) to 100 bar (1450 p si) higher than the the Swage Pressure to minimise the

risk of Bobt ail (the p art of the Fastener held by the Nose Assembly), fracture.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 50 51

No comments

Alcoa SFBTT20-IT SFBTT20-IT Instruction Manual Page 9