Alcoa SFBTT20-IT SFBTT20-IT Instruction Manual download pdf (Page 8)

Intended Use

The 911D Powerig is designed to be used

with Huck Installation Tools (refer to

Utilisation on Page 5), to install various

Huck Bobtail Fasteners, in a factory

(where permitted),or outdoor working

environment. The unit should be not be

placed on a surface with an angle

exceeding 15 degrees from the horizontal.

Noise

The sound measurement is in accordance

with BS EN ISO 3746: 1996 is less than

70dB(A).

Disposal

Fluids should be disposed of by

processing through authorised methods

and in accordance with current legislation.

This symbol indicates that this product

must be disposed of according to the

WEEE Directive and our national law.

Products of this nature should be

forwarded to a designated collection point

e.g. on an authorised one-for-one basis

when you buy a similar new product or to

an authorised collection site for recycling

waste electrical and electronic equipment

(EEE). Improper handling of this type of

waste could have a possible negative

impact on the environment and human

health due to potentially hazardous

subst ances that are generally associated

with EEE. At the same time, your co-

operation in the correct disposal of these

product s will contribute to the ef fective

usage of natural resources.

Special Note

The 911D Series Powerigs include a 12

VDC 55 Amp Hour Lead Acid Battery.

Batteries are classed as hazardous waste

and should be disposed of in accordance

with legal requirement s.

For more information with respect to the

management of waste equipment for

recycling please cont act our Customer

Services desk at Alcoa Fastening

Systems Ltd, Telford Shropshire TF3 3BQ.

The Producer Identification Number for

Alcoa Fastening Systems Lt d, Telford is:

WEE/AF0044SY

The Waste Electrical &

Electronic Equipment

Regulations 2006

CAUTION

THE HYDRAULIC OUTPUT PRESSURE

VALVES (PULL & RETURN) ON THIS

POWERIG MAY HAVE BEEN SET AND

SEALED BY THE MANUFACTURER

AND SHOULD ONLY BE CHANGED IN

ACCORDANCE WITH THE

INSTRUCTIONS SHOWN IN THIS

MANUAL.

ANY NEW PRESSURES SET MUST

ALWAYS BE CHECKED AND TESTED.

CAUTION

THE POWERIG SHOULD NOT BE USED

AS A STEP. NO PERSON SHOULD

CLIMB ON THE POWERIG.

CAUTION

THE POWERIG SHOULD NOT BE USED

IN AN EXPLOSIVE AND/OR HIGHLY

FLAMMABLE ATMOSPHERE

Notes:

1) If the Powerig is delivered without an Installation Tool, Pull Pressure is factory preset at

510 bar, (7400 psi).

2) If the Powerig is delivered without an Installation Tool, Return Pressure is factory

preset at 221 bar, (3200 psi).

!""#$%&'()*+$,()*(-$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$./0&1$21-3(4*4+$,5-3(6-

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 50 51

Comments to this Manuals

No comments

Alcoa SFBTT20-IT SFBTT20-IT Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Alcoa SFBTT20-IT SFBTT20-IT